Joint sealing: the decisions to make before application

Substrate, joint geometry, backing and site conditions belong in the same plan as the sealant itself.

Sika construction bonding and sealing application

Identify the joint and its exposure

For a facade connection, “outdoor use” is not a complete specification. Identify both substrates, expected movement, weather exposure, any planned coating and whether the work is new or a refurbishment. Floor joints, facade joints and specialist seals serve different purposes. A product used successfully elsewhere still needs to be checked against this joint.

Sika lists Sikaflex Construction Purform for facade joint sealing. That is a starting point for selection, not permission to substitute it for every sealant. Check the local product data sheet against the project requirements.

Resolve joint geometry before ordering

Joint width and depth need to suit the expected movement and selected sealant. Resolve the backing arrangement during preparation. Sika’s Construction+ data sheet treats joint dimensions and backing as part of the application, so these should not be improvised from leftover materials on site. Report differences between the drawing and the actual joint before sealing; unusual details may need designer and manufacturer input.

Prepare the substrate before priming

Inspect joint edges for loose material, dust and remnants of earlier products. Sika’s Primer-3 N guidance makes clear that a primer promotes adhesion but does not replace correct cleaning. Whether a primer or activator is needed depends on the substrate and sealant combination. Follow the appropriate preparation instructions and flash-off times rather than applying a familiar product by habit.

Plan the work around site conditions

Agree the sequence and handover to following trades before application. Check storage and application conditions, product condition and the safety data sheet. Surface skin formation does not mean full cure, so schedule subsequent work using the selected product’s instructions. An agreed sample section can establish appearance, edge treatment and inspection expectations before the full facade is started.

Give purchasing a complete brief

Base quantities on the surveyed joint length and approved cross-section, allowing for the actual installation. For a Ferroszerszám enquiry, include substrate materials, joint dimensions, location and planned start date. Detail and wider-context photographs help, but do not replace drawings or the designer’s requirements. This gives product selection, accessories and pack sizes a clear basis and exposes missing information before delivery.

For refurbishment, describe the existing failure: where separation occurred, the condition of the joint edges and any known previous product. This helps identify further checks. The old cartridge name alone is not a survey; the condition of the actual connection matters to repair planning.

Technical sources

Loading...
Back to top